Proviso Systems Ltd

The Condition Monitoring Experts

Call Me Back

FLIR CM83 Power Clamp Meter Features

VFD Mode

Accurately analyse non-sinusoidal waveforms and noisy signals in VFD-controlled equipment.

Harmonics Mode

Locate noise from different electrical draws to realign harmonics and reduce electro-mechanical equipment stress.

Phase Rotation

Analyse three-phase systems to measure power draw and verify if power is evenly balanced.

Inrush Current

Measure hard and soft start-up inrush current spikes while equipment is ramping up.

METERLiNK Compatibility

Embed electrical measurements into thermal images captured by METERLiNK-enabled FLIR IR cameras for easier documentation.

Power Factor and Active Power

Monitor power quality improvements, such as start-up realignments on three-phase equipment.

Bluetooth Connectivity

Connect to Android devices for remote diagnostics in hard-to-reach or hazardous areas. Also, upload data without the need for special cords.

Bright Dual-LED Worklights

Make your work safer/easier in poorly lit locations – especially useful when the lights are out or obstacles block your inspection targets.

Rugged & Shock-Resistant

Double-molded case design and extra thick rubber on the corners absorbs shock to enhance job-site reliability and long-haul durability.



CM83 - VFD Mode

CM83 - Inrush Current

 

Technical Summary Range Basic Accuracy
AC/DC current 600A ±2%
AC/DC voltage 1000V ±1% / 0.7%
Harmonics 1st-25th order ±5%
Total harmonic distortion 0.0 to 99.9% ±3%
Inrush current 600ACA (Integration time 100ms) ±3 %
Active power 10kW to 600kW (10V, 5A min) ±3%
Diode test 0.4 to 0.8V ±0.1V
Capacitance 3.999mF Max ±1.9%
Resistance 99.99kΩ Max ±1%
Continuity threshold 30Ω ±1%
Frequency 20.00Hz to 9.999kHz ±0.5%

 

General Information
Jaw opening 1.45in (37mm, 1000MCM)
Category rating CAT IV-600V, CAT III-1000V
Bluetooth range Max 32ft (10m)
Warranty Limited lifetime*

 

 

Ordering Information

CM83: 600A true RMS AC/DC power clamp
CM83-NIST: CM83 with certificate of traceability to NIST
TA80: CAT IV silicon test leads

 

Contact Us