FLIR CM82 Power Clamp Meter Features
VFD Mode
Accurately analyse non-sinusoidal waveforms and noisy signals in VFD-controlled equipment.
Harmonics Mode
Locate noise from different electrical draws to realign harmonics and reduce electro-mechanical equipment stress.
Phase Rotation
Analyse three-phase systems to measure power draw and verify if power is evenly balanced.
Inrush Current
Measure hard and soft start-up inrush current spikes while equipment is ramping up.
Power Factor and Active Power
Monitor power quality improvements, such as start-up realignments on three-phase equipment.
Bright Dual-LED Worklights
Make your work safer/easier in poorly lit locations – especially useful when the lights are out or obstacles block your inspection targets.
Rugged & Shock-Resistant
Double-molded case design and extra thick rubber on the corners absorbs shock to enhance job-site reliability and long-haul durability.
CM82 Power Clamp Specifications
| Technical Summary | ||
|---|---|---|
| Range | Basic Accuracy | |
| AC/DC Current | 600 A | +/- 2% |
| AC/DC Voltage | 1000 V | +/- 1% / 0.7% |
| AC VFD Voltage | 1000 V | +/- 1% |
| Harmonics | 1st-25th Order | +/- 5% |
| Total Harmonic Distortion | 0.0 to 99.9% | +/- 3% |
| Inrush Current | 600 ACA Max (Integration Time 100 ms) | +/- 3% |
| Active Power | 10 kW to 60 kW, (10 V, 5 A min) | +/- 3% |
| Diode Test | 0.4 to 0.8 V | +/- 0.1V |
| Capacitance | 3.999 mF Max | +/- 1.9% |
| Resistance | 99.99 kΩ Max | +/- 1% |
| Continuity Threshold | 30 Ω | +/- 1% |
| Frequency | 20.00 Hz to 9.999 kHz | +/- 0.5% |
| General Information | ||
| Jaw Opening | 37 mm (1.45”, 1000MCM) | |
| Category Rating | CAT IV-600V, CAT III-1000V | |
| Bluetooth Range Max | N/A | |
| Battery Type | 6 x AAA | |
| Warranty | Limited Lifetime | |
For more information please contact us directly.
